I would like to have a formed skin if they ever become available again. May 25, 7, Ft. It looked good for about a year and the second year it was pretty scratched up but I just sold the car or I would have removed it. I was beside myself, but toothpaste worked great in removing everything. I was quoted about installed which seems high but watching Denis remove just 1 fender I sure would hate to pay for a windshield replacement. Mine has gotten very buggy in the past, and on the the trip to VIR some axle grease got all over it. If you can afford it, I say why not?
Nevertheless, I think anyone going into this fairly expensive item would be wise to reach an agreement with the installer about clarity. Do you recommend it? May 25, 7, Ft. I just took a chance based on, well I have Suntek clearbra on my full hood and front bumper. This gives a pre-formed, pre-cut skin for each specific application. This is my preliminary evaluation after two daytime drives. It did it’s job.
I will try and see how it goes. The skin on my Gray car has taken some severely major hits. I have Suntek clearbra on my full hood and front bumper. I watched the YouTube videos of this guy thowing a rock and using a hammer and he could not break the window. He said that it usually lasts 7 months to a year depending on how often it is in the sun. I took windsnield photo of a plastic bag to give an idea of what the ClearPlex looks like.
I think some good exposure to some hot sunlight would cure that. I am really happy with the install. He set up the group buy for us and I bought two-one as a spare.
I still had small pitting or nick.
I have been very satisfied with both the installation and protection of the windshields by the ClearPlex product. So, I had ClearPlex installed, with the hope that it would perform as advertised. They said the new film is actually better but they did not have access to a Ford GT windshield to make the specifically thermally formed units. RCorsa May 23, I’ll check clearplfx out at Amazon.
ClearPlex Windshield Film Review
I haven’t given up on a solution. Now I sometimes don’t even remember it’s there. I hada window tinet guy do it and it is damn near perfect after all these years.
I got my film from Trent.
ClearPlex Windshield Film Review | The Ford GT Forum
They say that it is not worth it. I think I’m being OCD about this. It looks like highly concentrated resin based spray that you leave on the surface for 2 minutes and wipe off. Key is installer claerplex and product selection, I can’t remember what was installed on my windshield 3M or Xpelnoticed few small waves across sideways for a couple of days and then the sun took care of the minor distortions, Dr.
Le Mans Supporter. You might contact Mike at Clearplex – or mike clearplexdirect. I’ll upload pics of before and after.
ClearPlex was installed yesterday. I’ve removed one and replaced due to track rash, that fine spray of asphalt on tracks, and the underlying glass was perfect. Many people have been in my car and have never even said anythingthey don’t notice it. May 25, 7, Ft.
They’re the ones that told me they didn’t want to be involved originally with direct marketing. Unlike Brian Stormcat and Frank fjpikulboth of mine were cut from sheet and then installed.
Glass shops do not use the proper epoxy that holds the windshield in place so during an accident the airbag on the passenger side knocks the windshield out making it ineffective for your passenger.
Clearplex windshield protection. Any experience? Do you recommend it? | Tesla
The effect of the ClearPlex is somewhat like a diffraction grating. This deletes the area that appeared black. Since it is not a permanent coating, I assume it will go away eventually.
I’m not so sure about this product.
Thread starter Xcentric Start date Mar 8, The Bray Group informed me they would not allow any dealers to install it unless they had an infrared dryer because people were upset with the curing process with normal heat and evaporation. It is possible the one on your car was “off the roll” and had to be formed on the car which would leave striations based on the uneven heating. With that as background and caveats, my first drive Even the other GT owners that have driven my car have never mentioned it.
If it doesn’t improve dramatically with curing, I am going to tear this stuff off.